Make sure you pass in the partition and not the entire disk.In Linux, disks have names like sda, sdb, hda, etc.The partitions on these disks have a number appended to the end. Creating a Disk Partition in Linux. Each partition is treated as a separate disk with its own file system.
How to: Disk partitioning for Linux and Windows dual-booting. A DOS partition table's partition types are primary, logical, and extended. In a GPT partition table, the partition type is used as the partition name.

Various utilities are available to display and manipulate the partition table. One of the most confusing and intimidating parts of installing Linux for dual-booting with Windows is the disk partitioning required. As I enter ‘p‘, it … From the command mode, enter ‘p‘ instead of ‘m‘ as we did earlier.

4. Save and quit: Changes are automatically saved when you quit parted. [[email protected] ~]# fdisk /dev/sda. w write the new partition table and exit . So we would want to use something like sda1 and not sda.. sudo mkfs.ext4 -L datapartition /dev/sda1; If you want to change the partition label at a later date, you can use the e2label command:
7. The first step is to view the partition table or layout on all block devices. Print all Partition Table in Linux. You can do this using parted or … Partitioning divides a disk drive into one or more logical disks. d delete a partition . 5.1. fdisk usage fdisk is started by typing (as root) fdisk device at the command prompt.device might be something like /dev/hda or /dev/sda (see Section 2.1.1).The basic fdisk commands you need are: p print the partition table .

Providing a partition name under GPT is a must; in the above example, primary is the name, not the partition type. n create a new partition . In this section, we will explain how to partition a storage disk in Linux using the parted command. 1. fdisk 2. cfdisk 3. parted To print all partition table of hard disk, you must be on command mode of specific hard disk say /dev/sda. q quit without saving changes . Partition information is stored in a partition table.

$ sudo parted -l Model: ATA ST3500418AS (scsi) Disk /dev/sda: 500GB Sector size (logical/physical): 512B/512B Partition Table: msdos Number Start End Size Type File system Flags 1 32.3kB 75.2GB 75.2GB primary ntfs boot 2 75.2GB 500GB 425GB extended lba 5 75.2GB 180GB 105GB logical ntfs 6 180GB 285GB 105GB logical ext4 7 285GB 287GB 2047MB logical linux-swap(v1) 8 287GB 500GB …

This helps you identify the storage device you want to partition.